Comfort TU600 for sliding gates up to 600 kg, 230 V AC motor, 16 cm/s, 868 MHz bi.linked
Prices are only visible after login.
Scope of delivery:
- Motor unit with integrated control Control CBX102B
- Digital 992 Universal receiver, 868 MHz bi.linked
- 2 Digital 572 Micro hand transmitter 2-channel, 868 MHz bi.linked
- LS22 Throughbeam photoelectric sensor without connecting cable
- Spur gear module 4 pre-mounted
- Floor console
Operator – Features:
- Active closing edge protection necessary
- End position setting via electronic limit switch
- Control with auto set function
- Foundation plate included
Control – End position setting:
Control – Operation:
Control – Structure and connection:
Control – Functions:
- Soft start/soft stop/soft run
- Automatic feed function
- Gate open time and prewarning time separately programmable
- Lighting duration programmable and switchable by radio
- Partial opening programmable
- Cycle counter
- Error signaling
- Simple reset function (complete reset)
Control – Operation:
- Same programming logic for all controls - CBX102B, CBX10224 and CBX20224
- 2 menus: simple and advanced - for easy programming, but customizable installation
Control – Structure and connection:
- Connection (conventional) for push button
- Connection (conventional) for 4-wire photoelectric sensor OPEN and CLOSED
- Connection (conventional) for holding circuit
- Connection (conventional) for 8.2 kOhm contact strip
- Connection (conventional) for signal light 230 V-AC
- Output 24 V-DC, max. 500 mA
* The values given were determined for an even distribution of the cycles. A cycle consists of two movements (opening and closing) and has a deflection of 10 revolutions of the output shaft in each direction. At ambient temperatures between 40°C and 60°C, a reduction of the maximum cycles per hour by 50% must be taken into account.
** For vertically moving doors and roller shutters, a reduction of the specified pull force by a further 20% may be necessary. Possible reasons for this are, for example, additional seals, double-walled profiles or an unfavorable winding ratio where the door height exceeds the door width. In addition, it should be noted that the maximum torque only occurs after one to two revolutions when thick or high profiles are used.
*** Alternative limit switch ratios are available upon request.
* The values given were determined for an even distribution of the cycles. A cycle consists of two movements (opening and closing) and has a deflection of 10 revolutions of the output shaft in each direction. At ambient temperatures between 40°C and 60°C, a reduction of the maximum cycles per hour by 50% must be taken into account.
** For vertically moving doors and roller shutters, a reduction of the specified pull force by a further 20% may be necessary. Possible reasons for this are, for example, additional seals, double-walled profiles or an unfavorable winding ratio where the door height exceeds the door width. In addition, it should be noted that the maximum torque only occurs after one to two revolutions when thick or high profiles are used.
*** Alternative limit switch ratios are available upon request.
Remser Brook 11
33428 Marienfeld
For questions to the manufacturer, please use this Contact form.
Prices are only visible after login.
Prices are only visible after login.
Prices are only visible after login.
Prices are only visible after login.
Prices are only visible after login.
